Minimum tank size
Oklahoma is selected. Choose your bedrooms and press Calculate.
Drain field suitability in Texas County
About 52% of rated land in Texas County is not limited or only somewhat limited, so a conventional trench system is often workable once a site evaluation confirms it.
- 3% not limited
- 45% somewhat limited
- 44% very limited
- 8% not rated (urban land, water, pits)
Share of the soil survey area's 1,310,915 acres, by the USDA rating “ENG – Septic Tank Absorption Fields”. Ratings assume a standard gravity trench system with no site changes, so “very limited” means a conventional field needs special design, not that septic is impossible.
What limits drain fields here
The most common limiting factors in Texas County, as a share of all its land. One soil can have several, so the figures overlap.
Slow-draining subsoil84% of the county
Water moves too slowly through the soil 2 to 6 feet down, so effluent can back up or surface.
Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
Steep slopes16% of the county
Slopes over about 8% make it hard to keep trenches level and can let effluent seep out downhill.
Trenches are laid along the contour, often with serial distribution or drip dispersal.
High water table5% of the county
The water table rises to within 4 to 6 feet of the surface for part of the year, leaving too little dry soil to treat effluent.
Mounds, sand filters or treatment units that need less separation are common answers.
Flood-prone ground4% of the county
The soil is on ground that floods, even if rarely, and a flooded drain field stops working.
Systems are placed above flood level, with watertight tanks and backflow protection.
Poor filtering layer3% of the county
Very permeable material 2 to 5 feet down filters effluent poorly.
Pretreatment or added fill gives the effluent more treatment before it reaches that layer.
Main soils in Texas County
The soils and land types covering the most ground. Search your address in the USDA Web Soil Survey to see which one is on your lot.
| Soil or land type | Share of county |
|---|---|
| Gruver | 24.4% |
| Ulysses | 12.3% |
| Dalhart | 10.0% |
| Potter | 6.6% |
| Conlen | 6.4% |
| Sherm | 5.5% |
| Veal | 5.2% |
| Vona | 3.8% |
Oklahoma tank size rules
1,000 gallons for 4 or fewer bedrooms, plus 250 gallons for each additional bedroom (DEQ Appendix H size charts).
| Bedrooms | Minimum tank |
|---|---|
| 1 BR | 1,000 gal |
| 2 BR | 1,000 gal |
| 3 BR | 1,000 gal |
| 4 BR | 1,000 gal |
| 5 BR | 1,250 gal |
| 6 BR | 1,500 gal |
Source: OAC 252:641-7 and Appendix H.
Common questions
Can I put a conventional septic system in Texas County?
Often, but not everywhere. The USDA rates 52% of rated land here as not or only somewhat limited for a standard drain field and 48% as very limited. Only a site evaluation on your lot can say which you have.
What size septic tank do I need in Texas County?
Oklahoma's minimum is 1,000 gal for 3 bedrooms and 1,000 gal for 4. Your county can require more.
What is the most common septic problem with soil in Texas County?
Slow-draining subsoil, a limiting factor on about 84% of the county. Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
More in Oklahoma
Sources
- https://sdmdataaccess.sc.egov.usda.gov/
- https://websoilsurvey.nrcs.usda.gov/app/
- https://www.nrcs.usda.gov/resources/data-and-reports/soil-survey-interpretations
- https://www.epa.gov/septic/types-septic-systems
- https://www.scribd.com/doc/68512720/Household-Waste-Water-Systems
- https://pubs.nmsu.edu/_m/M113/