Minimum tank size
Texas is selected. Choose your bedrooms and press Calculate.
Drain field suitability in Jim Wells County
Soils in Jim Wells County are mixed: 73% of rated land is very limited and 27% is not or only somewhat limited. The answer depends on the lot, so the soil test matters more than the county average.
- 0% not limited
- 23% somewhat limited
- 62% very limited
- 15% not rated (urban land, water, pits)
Share of the soil survey area's 556,081 acres, by the USDA rating “ENG – Septic Tank Absorption Fields”. Ratings assume a standard gravity trench system with no site changes, so “very limited” means a conventional field needs special design, not that septic is impossible.
What limits drain fields here
The most common limiting factors in Jim Wells County, as a share of all its land. One soil can have several, so the figures overlap.
Slow-draining subsoil79% of the county
Water moves too slowly through the soil 2 to 6 feet down, so effluent can back up or surface.
Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
High water table19% of the county
The water table rises to within 4 to 6 feet of the surface for part of the year, leaving too little dry soil to treat effluent.
Mounds, sand filters or treatment units that need less separation are common answers.
Ponding10% of the county
Water stands on the surface for hours after rain, which saturates the drain field.
Sites are often raised with a mound or moved to higher ground on the lot.
Hardpan or caliche10% of the county
A cemented layer within about 3 to 6 feet blocks downward drainage.
Trenches may be dug through the pan, or a mound placed above it.
Flood-prone ground6% of the county
The soil is on ground that floods, even if rarely, and a flooded drain field stops working.
Systems are placed above flood level, with watertight tanks and backflow protection.
Main soils in Jim Wells County
The soils and land types covering the most ground. Search your address in the USDA Web Soil Survey to see which one is on your lot.
| Soil or land type | Share of county |
|---|---|
| Opelika | 12.6% |
| Delfina | 11.2% |
| Lattas | 10.1% |
| Pernitas | 6.5% |
| Runge | 5.7% |
| Czar | 4.8% |
| Papalote | 4.2% |
| Clareville | 4.2% |
Texas tank size rules
Texas sets a daily design flow from bedrooms and living area (Table III), then sizes the tank from that flow (Table II): up to 250 gallons a day needs 750 gallons, 251 to 350 needs 1,000, 351 to 500 needs 1,250, and 501 to 1,000 needs 2.5 times the flow. The figures here assume the living area fits the bedroom count, for example under 2,500 sq ft for 3 bedrooms. Water-saving fixtures throughout lower the design flow.
| Bedrooms | Minimum tank |
|---|---|
| 1 BR | 750 gal |
| 2 BR | 750 gal |
| 3 BR | 1,000 gal |
| 4 BR | 1,250 gal |
| 5 BR | 1,250 gal |
| 6 BR | 1,313 gal |
Source: 30 TAC 285.91, Tables II and III.
Common questions
Can I put a conventional septic system in Jim Wells County?
Often, but not everywhere. The USDA rates 27% of rated land here as not or only somewhat limited for a standard drain field and 73% as very limited. Only a site evaluation on your lot can say which you have.
What size septic tank do I need in Jim Wells County?
Texas's minimum is 1,000 gal for 3 bedrooms and 1,250 gal for 4. Your county can require more.
What is the most common septic problem with soil in Jim Wells County?
Slow-draining subsoil, a limiting factor on about 79% of the county. Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
More in Texas
Sources
- https://sdmdataaccess.sc.egov.usda.gov/
- https://websoilsurvey.nrcs.usda.gov/app/
- https://www.nrcs.usda.gov/resources/data-and-reports/soil-survey-interpretations
- https://www.epa.gov/septic/types-septic-systems
- https://regulations.justia.com/resources/v2025050500/tx/admin/2025/tx30_285_91_200804579_4.pdf
- https://pubs.nmsu.edu/_m/M113/