Septic Tank Calculator

Home / By county / Washington

Septic Systems in Yakima County Area, Washington

How much of Yakima County Area the USDA rates as suitable for a septic drain field, what usually limits it, and the tank size Washington requires.

Count every room that could be used as a bedroom. Most states size the tank by bedrooms, not by who lives there now.
Used only for the pumping estimate.

Minimum tank size

Washington is selected. Choose your bedrooms and press Calculate.

Drain field suitability in Yakima County Area

Soils in Yakima County Area are mixed: 75% of rated land is very limited and 25% is not or only somewhat limited. The answer depends on the lot, so the soil test matters more than the county average.

  • 1% not limited
  • 24% somewhat limited
  • 74% very limited
  • 1% not rated (urban land, water, pits)

Share of the soil survey area's 866,232 acres, by the USDA rating “ENG – Septic Tank Absorption Fields”. Ratings assume a standard gravity trench system with no site changes, so “very limited” means a conventional field needs special design, not that septic is impossible.

What limits drain fields here

The most common limiting factors in Yakima County Area, as a share of all its land. One soil can have several, so the figures overlap.

  • Slow-draining subsoil72% of the county

    Water moves too slowly through the soil 2 to 6 feet down, so effluent can back up or surface.

    Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.

  • Steep slopes67% of the county

    Slopes over about 8% make it hard to keep trenches level and can let effluent seep out downhill.

    Trenches are laid along the contour, often with serial distribution or drip dispersal.

  • Large stones35% of the county

    Stones over 3 inches make up a quarter or more of the top 16 inches, which makes trenches hard to dig and level.

    Contractors may need heavier equipment or imported fill.

  • Shallow bedrock32% of the county

    Rock lies within about 3 to 6 feet of the surface, so there is little soil to filter effluent before it reaches the rock.

    At-grade systems, mounds or drip dispersal add soil depth above the rock.

  • Hardpan or caliche12% of the county

    A cemented layer within about 3 to 6 feet blocks downward drainage.

    Trenches may be dug through the pan, or a mound placed above it.

Main soils in Yakima County Area

The soils and land types covering the most ground. Search your address in the USDA Web Soil Survey to see which one is on your lot.

Soil or land typeShare of county
Warden10.1%
Ritzville9.0%
Jumpe6.2%
Rock Creek5.0%
Sutkin3.6%
Harwood3.3%
Lickskillet3.1%
Esquatzel3.1%

Washington tank size rules

Homes with up to 4 bedrooms need 1,000 gallons. Add 250 gallons for each additional bedroom.

BedroomsMinimum tank
1 BR1,000 gal
2 BR1,000 gal
3 BR1,000 gal
4 BR1,000 gal
5 BR1,250 gal
6 BR1,500 gal

Source: WAC 246-272A-0232, Table VII.

All Washington septic rules

Common questions

Can I put a conventional septic system in Yakima County Area?

Often, but not everywhere. The USDA rates 25% of rated land here as not or only somewhat limited for a standard drain field and 75% as very limited. Only a site evaluation on your lot can say which you have.

What size septic tank do I need in Yakima County Area?

Washington's minimum is 1,000 gal for 3 bedrooms and 1,000 gal for 4. Your county can require more.

What is the most common septic problem with soil in Yakima County Area?

Slow-draining subsoil, a limiting factor on about 72% of the county. Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.

Sources

  • https://sdmdataaccess.sc.egov.usda.gov/
  • https://websoilsurvey.nrcs.usda.gov/app/
  • https://www.nrcs.usda.gov/resources/data-and-reports/soil-survey-interpretations
  • https://www.epa.gov/septic/types-septic-systems
  • https://lawfilesext.leg.wa.gov/Law/WAC/WAC%20246%20%20TITLE/WAC%20246%20-272A%20CHAPTER/WAC%20246%20-272A-0232.htm
  • https://pubs.nmsu.edu/_m/M113/