Minimum tank size
Virginia is selected. Choose your bedrooms and press Calculate.
Drain field suitability in Washington County Area and the City of Bristol
Soils in Washington County Area and the City of Bristol are mixed: 79% of rated land is very limited and 21% is not or only somewhat limited. The answer depends on the lot, so the soil test matters more than the county average.
- 0% not limited
- 20% somewhat limited
- 74% very limited
- 6% not rated (urban land, water, pits)
Share of the soil survey area's 286,113 acres, by the USDA rating “ENG – Septic Tank Absorption Fields”. Ratings assume a standard gravity trench system with no site changes, so “very limited” means a conventional field needs special design, not that septic is impossible.
What limits drain fields here
The most common limiting factors in Washington County Area and the City of Bristol, as a share of all its land. One soil can have several, so the figures overlap.
Steep slopes93% of the county
Slopes over about 8% make it hard to keep trenches level and can let effluent seep out downhill.
Trenches are laid along the contour, often with serial distribution or drip dispersal.
Slow-draining subsoil65% of the county
Water moves too slowly through the soil 2 to 6 feet down, so effluent can back up or surface.
Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
Shallow bedrock49% of the county
Rock lies within about 3 to 6 feet of the surface, so there is little soil to filter effluent before it reaches the rock.
At-grade systems, mounds or drip dispersal add soil depth above the rock.
Drains too fast26% of the county
Coarse soil at the bottom of the trench passes effluent through before it is treated, which risks groundwater.
Pretreatment units or a sand liner slow the flow and finish the treatment.
Flood-prone ground7% of the county
The soil is on ground that floods, even if rarely, and a flooded drain field stops working.
Systems are placed above flood level, with watertight tanks and backflow protection.
Main soils in Washington County Area and the City of Bristol
The soils and land types covering the most ground. Search your address in the USDA Web Soil Survey to see which one is on your lot.
| Soil or land type | Share of county |
|---|---|
| Frederick | 27.8% |
| Westmoreland | 10.8% |
| Weikert | 9.3% |
| Hagerstown | 7.8% |
| Lily | 6.4% |
| Litz | 4.7% |
| Marbie | 3.3% |
| Wyrick | 2.9% |
Virginia tank size rules
Homes with up to 2 bedrooms need 750 gallons, 3 bedrooms 900, 4 bedrooms 1,200 and 5 bedrooms 1,500. Larger homes are sized for 48 hours of design flow.
| Bedrooms | Minimum tank |
|---|---|
| 1 BR | 750 gal |
| 2 BR | 750 gal |
| 3 BR | 900 gal |
| 4 BR | 1,200 gal |
| 5 BR | 1,500 gal |
| 6 BR | Set locally |
Source: 12VAC5-610-815(A), Table 5.2.
Common questions
Can I put a conventional septic system in Washington County Area and the City of Bristol?
Often, but not everywhere. The USDA rates 21% of rated land here as not or only somewhat limited for a standard drain field and 79% as very limited. Only a site evaluation on your lot can say which you have.
What size septic tank do I need in Washington County Area and the City of Bristol?
Virginia's minimum is 900 gal for 3 bedrooms and 1,200 gal for 4. Your county can require more.
What is the most common septic problem with soil in Washington County Area and the City of Bristol?
Steep slopes, a limiting factor on about 93% of the county. Trenches are laid along the contour, often with serial distribution or drip dispersal.
More in Virginia
Sources
- https://sdmdataaccess.sc.egov.usda.gov/
- https://websoilsurvey.nrcs.usda.gov/app/
- https://www.nrcs.usda.gov/resources/data-and-reports/soil-survey-interpretations
- https://www.epa.gov/septic/types-septic-systems
- https://law.lis.virginia.gov/admincode/title12/agency5/chapter610/section815/
- https://pubs.nmsu.edu/_m/M113/