Home / By county / Washington
Septic Systems in Lincoln County, Washington
How much of Lincoln County the USDA rates as suitable for a septic drain field, what usually limits it, and the tank size Washington requires.
Minimum tank size
Washington is selected. Choose your bedrooms and press Calculate.
Drain field suitability in Lincoln County
Most rated land in Lincoln County is very limited for a standard drain field: 82% of it. Expect a site evaluation to point many lots toward a larger field, pressure distribution or an engineered system.
- 0% not limited
- 18% somewhat limited
- 81% very limited
- 1% not rated (urban land, water, pits)
Share of the soil survey area's 1,418,084 acres, by the USDA rating “ENG – Septic Tank Absorption Fields”. Ratings assume a standard gravity trench system with no site changes, so “very limited” means a conventional field needs special design, not that septic is impossible.
What limits drain fields here
The most common limiting factors in Lincoln County, as a share of all its land. One soil can have several, so the figures overlap.
Slow-draining subsoil69% of the county
Water moves too slowly through the soil 2 to 6 feet down, so effluent can back up or surface.
Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
Steep slopes41% of the county
Slopes over about 8% make it hard to keep trenches level and can let effluent seep out downhill.
Trenches are laid along the contour, often with serial distribution or drip dispersal.
Shallow bedrock29% of the county
Rock lies within about 3 to 6 feet of the surface, so there is little soil to filter effluent before it reaches the rock.
At-grade systems, mounds or drip dispersal add soil depth above the rock.
Drains too fast14% of the county
Coarse soil at the bottom of the trench passes effluent through before it is treated, which risks groundwater.
Pretreatment units or a sand liner slow the flow and finish the treatment.
Large stones9% of the county
Stones over 3 inches make up a quarter or more of the top 16 inches, which makes trenches hard to dig and level.
Contractors may need heavier equipment or imported fill.
Main soils in Lincoln County
The soils and land types covering the most ground. Search your address in the USDA Web Soil Survey to see which one is on your lot.
| Soil or land type | Share of county |
|---|---|
| Bagdad | 15.6% |
| Renslow | 10.2% |
| Bakeoven | 6.6% |
| Rock outcrop | 6.1% |
| Broadax | 5.9% |
| Anders | 5.5% |
| Roloff | 5.4% |
| Ritzville | 5.0% |
Washington tank size rules
Homes with up to 4 bedrooms need 1,000 gallons. Add 250 gallons for each additional bedroom.
| Bedrooms | Minimum tank |
|---|---|
| 1 BR | 1,000 gal |
| 2 BR | 1,000 gal |
| 3 BR | 1,000 gal |
| 4 BR | 1,000 gal |
| 5 BR | 1,250 gal |
| 6 BR | 1,500 gal |
Source: WAC 246-272A-0232, Table VII.
Common questions
Can I put a conventional septic system in Lincoln County?
Often, but not everywhere. The USDA rates 18% of rated land here as not or only somewhat limited for a standard drain field and 82% as very limited. Only a site evaluation on your lot can say which you have.
What size septic tank do I need in Lincoln County?
Washington's minimum is 1,000 gal for 3 bedrooms and 1,000 gal for 4. Your county can require more.
What is the most common septic problem with soil in Lincoln County?
Slow-draining subsoil, a limiting factor on about 69% of the county. Designers usually answer with a larger drain field, shallower trenches, pressure dosing or a mound.
More in Washington
Sources
- https://sdmdataaccess.sc.egov.usda.gov/
- https://websoilsurvey.nrcs.usda.gov/app/
- https://www.nrcs.usda.gov/resources/data-and-reports/soil-survey-interpretations
- https://www.epa.gov/septic/types-septic-systems
- https://lawfilesext.leg.wa.gov/Law/WAC/WAC%20246%20%20TITLE/WAC%20246%20-272A%20CHAPTER/WAC%20246%20-272A-0232.htm
- https://pubs.nmsu.edu/_m/M113/