Septic Tank Calculator

Home / Tools

Septic Sludge Level Calculator

Enter the measurements from a sludge check and see whether your tank is due for pumping under the EPA's three tests, and roughly when it will be.

Tank floor to the liquid surface.
in
How far the outlet tee or baffle reaches below the liquid surface.
in
Thickness of the floating layer.
in
Thickness of the settled layer on the floor.
in
Optional. Used to project when the tank will be due.
yr

Pumping check

Enter your measurements and press Check my tank.

The EPA's three tests

The EPA says to pump the tank when any one of these is true:

  1. The bottom of the scum layer is within 6 inches of the bottom of the outlet.
  2. The top of the sludge layer is within 12 inches of the outlet.
  3. Scum and sludge together take up more than 25% of the liquid depth.

The calculator places the outlet bottom where the outlet tee or baffle ends, below the liquid surface, and measures both layers against it.

How the layers are measured

Inspectors measure through the outlet-side lid with a sludge-measuring tube or a marked pole: the scum thickness at the surface, and the sludge depth on the tank floor. Do it from outside the tank; the EPA warns tanks can hold dangerous gases. If you have no measurements, the pumping interval table gives a starting point by tank size and household.

Common questions

How often should a tank be measured?

At each inspection, at least every 3 years for a typical household system and about once a year for systems with pumps or other mechanical parts, according to the EPA.

Why does the outlet matter?

Scum or sludge that reaches the outlet flows into the drain field and clogs it, which is far more expensive to fix than a pumping.

Sources

  • https://www.epa.gov/septic/how-care-your-septic-system
  • https://www.epa.gov/ground-water-and-drinking-water/septic-systems-what-do-after-flood